Compatibilization of Vulcanized SBR/NBR Blends using Cis-Polybutadiene Rubber: Influence of Blend Ratio on Elastomer Properties

Blends composed of styrene butadiene rubber (SBR) and acrylonitrile-butadiene rubber (NBR) were fabricated by melt blending technique using two-roll mill blend machine. Cis- polybutadiene rubber (CBR) was used as a compatibilizer for enhancing the homogeneity between SBR and NBR phases in blends. Although, no previous reports were found to discuss improving electrical properties of vulcanized SBR/NBR blends using unfilled rubber system (i.e. no fillers incorporated). Raman spectra and SEM images indicate that a significant compatibility within the rubber matrix is observed, due to using CBR compatibilizer. The effect of SBR/NBR blend ratio on curing characteristics, physico-mechanical properties, and physicochemical properties (e.g. network characteristics and thermodynamic parameters) were studied. SBR/NBR blend showed comparatively better mechanical properties, compared to each other individually rubber system. Curing parameters e.g. Mooney viscosity and hardness were increased, while a reduction in cure time and specific gravity was observed with increasing SBR ratio in blends. Results revealed that increasing SBR resulted in an enhancement of the tensile strength, modulus at 300 % and elongation at break up to 40 phr, and then gradually decreased. The TGA results indicated that SBR/NBR blends were thermally decomposed at a temperature range of 340-520°C. The notable decrease of DC conductivity (σdc) of vulcanized blends is owing to the decrease of NBR, which is a polar portion and is responsible for increasing the conductivity of vulcanized blends. This proved that the targeted industrial applications for vulcanized blends are entirely depending upon SBR/NBR blend in elastomers matrix.