Effect of sintering temperature on phase evolution, microstructure, and mechanical properties of La2Ce2O7/40 wt.% YSZ composite ceramics

In this work, La2Ce2O7/40 wt% YSZ (LC40Z) mixed powders were used to fabricate composite bulk ceramics with their potential use as a material for high-performance thermal barrier coatings (TBCs). For this purpose, the effect of sintering temperature on the chemical reactivity of LC and YSZ was investigated via hot-pressing at the temperatures of 1300, 1400 and 1500 C. X-ray diffraction analysis (XRD), Raman spectroscopy, and scanning electron microscopy (SEM) were utilized to characterize the phase and microstructure evolution in both LC40Z powder mixtures and composite bulk ceramics. Results showed that solid-solution reactions occurred between the YSZ and LC during hot-pressing of the LC40Z powder mixtures, indicated by a new phase of La2Ce0$2Zr1$8O7 (LCZ) observed in the XRD patterns. The detailed analysis of Raman spectra confirmed the gradual transition from fluorite LC to pyrochlore LCZ structure, which was demonstrated by the appearance of characteristic pyrochlore bands. All composites densified by hot-pressing exhibited a high relative density above 95%. The average grain size of the LC40Z composites increased significantly with increasing sintering temperature, while gradual pore-healing was observed. The associated mechanical properties of LC40Z ceramics were also reported. The Vickers hardness values increased with increasing sintering temperature, which is consistent with the microstructure evolution and relative density variations. The highest hardness, with a value of 10.99 ± 0.23 GPa, was achieved for the composite hot-pressed at 1500 C. The fracture toughness results showed the same dependence on sintering temperature. The fracture toughness increased from 1.97 ± 0.15 to 2.4 ± 0.14 MPa m1/2, indicating that the mechanical properties of the LC40Z composites can be tailored by changing the sintering temperature during hot-pressing.