Taguchi Design for Wear Behaviour of Al-Si-B4C Composites Prepared by Powder Metallurgy

This research paper discuss about the wear loss behavior of Al-12Si-xB4C composites prepared through powder metallurgy method by varying the weight percentage of reinforcement (x = 2, 4, 6, 8, and 10) content. The samples were prepared by using die and punch assembly and the lubricant used to eject the sample from the die was molybdenum disulfide. The compaction was done by using compression testing machine by applying a pressure of 800MPa. The dry sliding wear loss behavior of the sample was conducted on Pin-on-Disc machine and the experimental values of wear loss were calibrated. Taguchi design experiment was done by applying L25 orthogonal array for 3 factors at 5 levels for the response parameter wear loss. Analysis of Variance demonstrated by Mean and S/N ratio table for wear loss was discussed and from the table it can be seen that the reinforcement plays a main role, when the compared with load and Sliding Distance (SD). The normal probability plot shows that the residuals falls near to the red line, it indicate that the error values were less in the model.