Single fiber tensile test - Glass and Carbon fibers

Single fiber test data and SEM scan behind the publications 

[1] Kumar, R., L.P. Mikkelsen, H. Lilholt, B. Madsen, Understanding the mechanical response of glass and carbon fibres: stress-strain analysis and modulus determination IOP Conf. Ser.: Mater. Sci. Eng. 942, 012033, https://doi.org/10.1088/1757-899X/942/1/012033, 2020

and

[1] Rajnish Kumar, Lars P Mikkelsen, Hans Lilholt and Bo Madsen, Experimental Method for Tensile Testing of Unidirectional Carbon Fibre Composites Using Improved Specimen Type and Data Analysis, Materials, 14, 3939, https://doi.org/10.3390/ma14143939, 2021.

to where a reference should be given. 

A video describing the test-setup can be found in the following link: https://panopto.dtu.dk/Panopto/Pages/Viewer.aspx?id=50c10945-0612-4126-9e99-b00700cfbaf2&start=0 

The data-set cover single fiber test of a carbon and glass fiber in the gauge section range from 20-80 mm for carbon fiber and from 40-80 mm for glass fiber. There are three files for each gauge-section:

... Data.xslx: The individual tensile curves with one sheet for each fiber. There are around 150 fibers in each set

... Results.xslx: One excel-sheet containing a summary of the parameters obtained for the individual fibers.

....Figures.doc: Word file showing a plot of the graphs 

In addition to this, there are for the carbon and glass fiber case a test setup complience calculation saved in the 

.... Compliance.xslx excel-sheet

and SEM scans of a large approximately 2x20 mm cross-section of a pultruded profile based on the carbon fibers. This scan can be used for validating the fiber diameter distribution found in the single fiber testing. The SEM scan is saved in the

Carbon_HyFisyn... files

This set of files also include a matlab file (.m) which are used for determine the fiber volume fraction of the composite.