The Examination of the Specific Thermal Resistivity And Moisture of Cable Bed In Laboratory Conditions

This paper at first hand briefly presents examples of the maximum permitted current changes for one cable depending on the specific thermal resistance soil value ρ_z. It is emphasized that the permanently permissible current load of the cable should be calculated using a constant value ρ_z in design - Then, for two cases from field, two samples were examined. The first sample is undisturbed soil from the cable route and the second sample is specially prepared cable bed. The corresponding ρ_z values were obtained using the needle probe method in the laboratory. The difference is pointed out between the measured values of specific thermal resistivity and moisture of the samples. Some samples were being dried in thermal chambers and the others were being dried on ambient temperature. For drying in thermal chambers, based on experience for cross-linked polyethylene cables, the temperatures of 60°C to 90°C were selected for the first case while in the second case the temperature of 20°C over a long period of time was applied. The results obtained were analyzed and shown in appropriate tables and graphs. At the end of this paper the moisture of the soil was calculated for sampled cable bed that corresponds to the value of ρ_z of 1(Km/W). The composition of the cable bed that allows the designed value of the rated power of the cable to be achieved is proposed..