Fabrication and Morphological Characterization of High-Efficiency Blade-Coated Perovskite Solar Modules
Authors/Creators
- 1. CHOSE—Centre for Hybrid and Organic Solar Energy, University of Rome Tor Vergata, via del Politecnico 1, Roma 00133, Italy
- 2. Department of Materials Science and Metallurgy, University of Cambridge, 27 Charles Babbage Road, Cambridge CB3 0FS, U.K.
- 3. Department of Materials Science and Metallurgy, University of Cambridge, 27 Charles Babbage Road, Cambridge CB3 0FS, U.K. and IPVF, Ile-de-France Photovoltaic Institute (IPVF), 30 Route Départementale 128, Palaiseau 91120, France
- 4. CHOSE—Centre for Hybrid and Organic Solar Energy, University of Rome Tor Vergata, via del Politecnico 1, Roma 00133, Italy and Italian National Agency for New Technologies, Energy and Sustainable Economic Development (ENEA), Energy Efficiency Unit Department, Via Anguillarese, 301, 00123 Santa Maria di Galeria, Rome, Italy
- 5. CHOSE—Centre for Hybrid and Organic Solar Energy, University of Rome Tor Vergata, via del Politecnico 1, Roma 00133, Italy and LASE—Laboratory for Advanced Solar Energy, National University of Science and Technology MISiS, Leninskiy Prospect, Moscow 119049, Russia
Description
Organo-metal halide perovskite demonstrates a large potential for achieving highly efficient photovoltaic devices. The scaling-up process represents one of the major challenges to exploit this technology at the industrial level. Here, the scaling-up of perovskite solar modules from 5 × 5 to 10 × 10 cm2 substrate area is reported by blade coating both the CH3NH3PbI3 perovskite and spiro-OMeTAD layers. The sequential deposition approach is used in which both lead iodide (PbI2) deposition and the conversion step are optimized by using additives. The PbI2 solution is modified by adding methylammonium iodide (MAI) which improves perovskite crystallinity and pore filling of the mesoporous TiO2 scaffold. Optimization of the conversion step is achieved by adding a small concentration of water into the MAI-based solution, producing large cubic CH3NH3PbI3 grains. The combination of the two modifications leads to a power conversion efficiency of 14.7% on a perovskite solar module with an active area of 47 cm2.
Notes
Files
Additional details
Funding
- European Commission
- MAESTRO - MAking pErovskiteS TRuly explOitable 764787
- European Commission
- ESPResSo - Efficient Structures and Processes for Reliable Perovskite Solar Modules 764047
- European Commission
- CHEOPS - Production technology to achieve low Cost and Highly Efficient phOtovoltaic Perovskite Solar cells 653296