Published July 27, 2026 | Version v1

A 7-year Validated Nitrate Dataset from the NSF Ocean Observatories Initiative Global Irminger Sea Array

Authors/Creators

  • 1. ROR icon Woods Hole Oceanographic Institution

Description

The Ocean Observatories Initiative (OOI) deployed both the In-Situ Ultraviolet Spectrophotometer (ISUS) and Submersible Underwater Nitrate Sensor (SUNA) for continuous, in-situ measurement of nitrate. At the Global Irminger Sea, ISUS/SUNA sensors were deployed both on the surface buoy at approximately 1 meter depth and on the Near-Surface Instrument Frame (NSIF) at 12 m depth. The SUNA sensor replaced the ISUS sensors spring 2018. The SUNA was a major improvement in technology, with significant improvements in accuracy and precision. However, it still suffers from calibration drift due to lamp fatigue and biofouling as well as spectral interference due to bromide and fluorometric CDOM. Drift is corrected by application of post-cruise calibrations to recalculate the temperature-and-salinity corrected nitrate concentration following Plant et al (2023) and estimating a linear drift between pre-and-post cruise deployments. Validation is performed by comparison with discrete water samples collected during deployment/recovery of the sensors. These datasets include the nitrate data from the Global Irminger Sea buoy (GI01SUMO-SBD11-08-NUTNRB000.nc) and NSIF (GI01SUMO-RID16-07-NUTNRB000.nc) SUNA instruments spanning Summer 2018 through Summer 2025. Each dataset contains the measured nitrate, the temperature-salinity corrected nitrate, the drift-corrected nitrate, and the nitrate following validation with bottle samples.

Methods

Datasets

SUNA datasets are known as “NUTNR” on OOI (Nutrient Sensor). NUTNR datasets predating spring 2018 are from the ISUS instrument and not used, due to known measurement issues that make a quantitative data quality assessment difficult. SUNA datasets at the Global Irminger Sea array begin with deployment 5 in the summer of 2018 and cover through summer 2025.

The SUNA datasets are downloaded on a deployment-by-deployment basis from the OOI Gold Copy THREDDs catalog. Each dataset additionally contains the practical salinity and seawater temperature measured by the collocated CTD on the mooring NSIF. This data is interpolated to the SUNA dataset timestamps and integrated into the dataset by OOI. Salinity and temperature are necessary to calculate the Sakamoto (2009) nitrate correction for salinity interference.

The SUNA datasets downloaded from the OOI Gold Copy THREDDS catalog contain the original Sakamoto (2009) correction. Each dataset has replaced that with the Plant et al (2023) nitrate correction for salinity interference, further modified by the Sakamoto (2017) pressure correction . This change may alter the corrected_nitrate_concentration by up to 2 uM/kg over the typical range of temperatures and salinities observed at OOI moorings.

 

Apply the Drift Correction

Drift in the observed nitrate is known to occur due to lamp aging and biofouling. The impact of lamp aging can be corrected for using a post-cruise calibration and calculating a linear change between the pre-and-post deployment calibrations following Palevsky et al (2023):

$$
\frac{\Delta NO_{3}}{day} = \frac{NO_{3}^{predeployment \ cal} - NO_{3}^{postdeployment \ cal}}{Predeployment \ date - postdeployment \ date}
$$

In practice, we don’t have the DI water dataset for the pre-and-post deployment calibrations, just the calibration files themselves. Instead, we recalculate the nitrate concentration timeseries using the post-deployment calibration and assume that the difference between the timeseries calculated with the pre-deployment calibration and post-deployment calibration at the start of the deployment is $\Delta NO_{3}$. This assumption is reasonable because, apart from burn-in, the sensor is lightly used pre-deployment and drift due to lamp aging is a function of lamp-use.

 

Bottle Correction

One of the primary purposes of the discrete water sampling data is for the evaluation and validation of OOI instrumentation.  Following the methods described in Palevsky et al. (2023), we use the bottle data collected during deployment and recovery of the SUNA sensors to correct for offsets and drift. This is done with the following equation:

$$
\frac{\Delta NO_{3}}{day}=\frac{(NO_{3}^{bottle}-NO_{3}^{SUNA})_{deployment}-(NO_{3}^{bottle}-NO_{3}^{SUNA})_{recovery}}{Recovery\ date-deployment\ date}
$$

and

$$
\Delta NO_{3}^{offset}=(NO_{3}^{bottle}-NO_{3}^{SUNA})_{deployment}
$$

which yields the following equation for calculating the bottle-adjusted nitrate:

$$
NO_{3}^{adj}(t)=NO_{3}^{obs}(t)+\frac{\Delta NO_{3}}{day}*\Delta t+\Delta NO_{3}^{offset}
$$

 

Apply Bottle Offsets

Next, the timeseries is smoothed using a 6-hour centered rolling average to reduce noise while preserving daily nutrient cycling patterns. Then, the deployment and recovery bottle nitrate and smoothed SUNA nitrate are matched based on time. If there is no SUNA nitrate data available within 3 days of the bottle data at recovery, we do not calculate a drift based on the bottle data. Instead, we apply only the offset correction using the $\Delta NO_{3}^{offset}$ value. Otherwise, we go ahead and calculate $\frac{\Delta NO_{3}}{day}$ and apply the above equation to arrive at our bottle-corrected nitrate $NO_{3}^{adj}$. 

 

Create the Final Datasets

Lastly, we want to take the datasets we've constructed above, clean them up, and save only the parameters of interest to us. In addition to the different nitrate concentration time series generated by the above steps, we also retained the salinity, sea water temperature, and the median-absolute-deviation for the nitrate value generated during the burst-averaging step.

Technical info

File name: GI01SUMO-SBD11-08-NUTNRB000.nc

  • Geographic  Coverage
    • Latitude range: 59.93295 to 59.93295
    • Longitude range: -39.46549 to -39.46549
  • Time coverage
    • Start time: 2018-06-08T17:30:00 UTC
    • End time: 2025-07-31T07:15:00 UTC
  • Parameters within file: "serial_number", "deployment", "sea_water_practical_salinity", "sea_water_temperature", "nitrate_concentration", "nitrate_concentration_qc_flag", "corrected_nitrate_concentration", "corrected_nitrate_concentration_qc_flag", "drift_corrected_nitrate", "drift_corrected_nitrate_qc_flag", "bottle_corrected_nitrate", "bottle_corrected_nitrate_qc_flag", "burst_median_absolute_deviation", "time"

File name: GI01SUMO-RID16-07-NUTNRB000.nc

  • Geographic  Coverage
    • Latitude range: 59.93295 to 59.93295
    • Longitude range: -39.46549 to -39.46549
  • Time coverage
    • Start time: 2018-06-08T17:30:00 UTC
    • End time: 2025-07-31T07:15:00 UTC
  • Parameters within file: "serial_number", "deployment", "sea_water_practical_salinity", "sea_water_temperature", "nitrate_concentration", "nitrate_concentration_qc_flag", "corrected_nitrate_concentration", "corrected_nitrate_concentration_qc_flag", "drift_corrected_nitrate", "drift_corrected_nitrate_qc_flag", "bottle_corrected_nitrate", "bottle_corrected_nitrate_qc_flag", "burst_median_absolute_deviation", "time"

Files

Files (40.8 MB)

Name Size
md5:26497f98ff12a9b54d6691ddd3c2c4c1
18.9 MB Download
md5:d5e8d5805a37470d5a1701259b34fabe
21.9 MB Download

Additional details

Funding

U.S. National Science Foundation
Research Infrastructure: Management and Operations of the Ocean Observatories Initiative (OOI 2.5) 2244833

Dates

Collected
2018-06-08/2025-07-31
GI01SUMO-SBD11-08-NUTNRB000.nc time range
Collected
2018-06-08/2025-07-31
GI01SUMO-RID16-07-NUTNRB000.nc time range

Software

References

  • Johnson, K. and Coletti, L.J. 2002. In situ ultraviolet spectrophotometry for high resolution and long-term monitoring of nitrate, bromide and bisulfide in the ocean. Deep-Sea Research I, 49, 1291–130 https://doi.org/10.1016/S0967-0637(02)00020-1
  • Palevsky, H.I., Clayton, S., et al. 2023. OOI Biogeochemical Sensor Data: Best Practices & User Guide, Version 1.1.1. Ocean Observatories Initiative Biogeochemical Sensor Data Working Group, 134pp. DOI: https://doi.org/10.25607/OBP-1865.2
  • Sakamoto, C.M., Johnson, K.S., and L.J. Coletti. 2009. Improved algorithm for the computation of nitrate concentrations in seawater using an in situ ultraviolet spectrophotometer. Limnology and Oceanography: Methods 7.1 (2009): 132-143. https://doi.org/10.3390%2Fs21030965
  • Sakamoto, C.M., Johnson, K.S., Coletti, L.J. and Jannasch, H.W. (2017). Pressure correction for the computation of nitrate concentrations in seawater using an in situ ultraviolet spectrophotometer. Limnol. Oceanogr. Methods, 15: 897-902. https://doi.org/10.1002/lom3.10209
  • Plant, J.N., Sakamoto, C.M., Johnson, K.S., Maurer, T.L. and Bif, M.B. (2023). Updated temperature correction for computing seawater nitrate with in situ ultraviolet spectrophotometer and submersible ultraviolet nitrate analyzer nitrate sensors. Limnol Oceanogr Methods, 21: 581-593. https://doi.org/10.1002/lom3.10566
  • NSF Ocean Observatories Initiative. (2014). Pioneer New England Shelf Offshore Surface Mooring [Nitrate Instrument (CP04OSSM-RID26-07-NUTNRB000) data from 2018-03-24 to 2022-10-23. JupyterHub. https://jupyter.oceanobservatories.org] DOI: 10.58046/OOI-CP04OSSM. Accessed 2025-01-03.
  • NSF Ocean Observatories Initiative. (2014). Global Irminger Sea Array Apex Surface Mooring [Nitrate Instrument (GI01SUMO-SBD11-08-NUTNRB000) data from 2018-06-08 to 2025-07-31. JupyterHub. https://jupyter.oceanobservatories.org] DOI: https://doi.org/10.58046/OOI-GI01SUMO. Accessed 2026-07-23.
  • NSF Ocean Observatories Initiative. (2014). Global Irminger Sea Array Apex Surface Mooring [Nitrate Instrument (GI01SUMO-RID16-07-NUTNRB000) data from 2018-06-08 to 2025-07-31. JupyterHub. https://jupyter.oceanobservatories.org] DOI: https://doi.org/10.58046/OOI-GI01SUMO. Accessed 2026-07-23.