Published June 26, 2026 | Version v1

DESIGN OF MICROCONTROLLER-BASED MODULAR POWER FACTOR CORRECTION BOOST CONVERTER WITH SILICON CARBIDE SEMICONDUCTOR MATERIALS

  • 1. ROR icon Izmir Kâtip Çelebi University

Description

Nonlinear loads cause harmonic currents and power factor distortions in power electronics systems. This increases distribution losses and leads to violations of international standards such as IEC 61000-3-2 and IEEE 519-2022. In this project, a modular Power Factor Correction (PFC) boost converter with a power of 2 kW and a 220 V AC input to a 600 V DC output was designed and validated in a simulation environment.
Silicon Carbide (SiC) MOSFETs and SiC Schottky barrier diodes were used instead of silicon components in the power stage. This choice provided low switching losses and superior thermal resistance. A dual-loop average current mode control algorithm was adopted; the outer loop output voltage was regulated while the inner loop input current was shaped sinusoidally. The algorithm was implemented on an ARM Cortex-M based STM32 NUCLEO-G474RE microcontroller in the STM32CubeIDE environment with a switching frequency of 20 kHz. Closed-loop simulation results show that the output voltage is regulated at 600 V, the power factor reaches 0.98, and all harmonic components remain within the IEC 61000-3-2 Class A limits. The calculated system efficiency is approximately 98%. In addition, the UCC21520DW isolated gate driver circuit was designed and manufactured as a PCB; it was experimentally verified with a 15 V output amplitude at 20 kHz. Thanks to its modular architecture, the system can be easily scaled to higher power levels by adding independently operating cells.

Files

DESIGN OF MICROCONTROLLER-BASED MODULAR POWER FACTOR CORRECTION BOOST CONVERTER WITH SILICON CARBIDE SEMICONDUCTOR MATERIALS.pdf