Case 1
=======================================================================
Verify that the progress bar is seen
=======================================================================
Steps
-----------------------------------------------------------------------
1. Run File > Open >
2. Select ./IntergrationTestLogs/AnisotropicHyperStack.zip
3. Run Plugins > BoneJ > Surface area >
4. Uncheck "Export STL file(s)"

Expected result
-----------------------------------------------------------------------
The progress bar advances in the lower right-hand corner of the ImageJ
main window. Progress resets for each subspace.

Completed September 10th 2018 Richard Domander
-----------------------------------------------------------------------


Case 2
=======================================================================
Verify that the progress bar is seen
=======================================================================
Steps
-----------------------------------------------------------------------
1. Run File > New > Hyper stack...
2. Select ./IntergrationTestLogs/AnisotropicHyperStack.zip
3. Run Plugins > BoneJ > Fraction > Surface fraction

Expected result
-----------------------------------------------------------------------
The progress bar advances in the lower right-hand corner of the ImageJ
main window. Progress resets for each subspace.

Completed September 10th 2018 Richard Domander
-----------------------------------------------------------------------